You have just installed a Cherubini radio motor, or yours lost its programming after a long power cut? Recommissioning follows a three-step logic: pairing, rotation direction, limit switches.

1. Pair the transmitter

With only this motor powered, long-press the transmitter's PROG key until the curtain jogs twice. The transmitter is registered.

2. Check the rotation direction

Press "up": if the curtain goes down, reverse the direction (holding STOP or a PROG sequence depending on the generation) before setting any stop. Setting limits with an inverted direction is the most frequent mistake.

3. Set the limit switches

Bring the curtain to the top point, adjust precisely, confirm as per the manual (often STOP + PROG).
Lower to the desired bottom point and confirm the same way.
Run two full cycles to check the stops.

Our technicians' tips

Never programme two new powered motors at the same time
On a shutter with automatic locks, set the bottom point with the curtain seated and locks engaged
Note the motor reference before closing the box: it will help at the next repair

A motor that refuses pairing or loses its settings may have tired electronics. Our teams replace Cherubini and compatible motorisations throughout Île-de-France.